सीधे मुख्य सामग्री पर जाएं

CBR Test

 Remoulded specimen: The test material

should pass 19mm IS sieve and retained on

4.75mm IS sieve. The dry density for a

remoulding shall be either the field density or

the value of the maximum dry density estimated

by the compaction test, Heavy Compaction

Test as per IS-2720 (Part-8):1983, for Railway

Formation. The water content used for

compaction shall be the optimum water content

or the field moisture as the case may be.

(ii) Dynamic Compaction: A representative

sample of the soil weighing approximately 4.5

kg or more for fine grained soil and 5.5 kg or

more for granular soil shall be taken and mixed

thoroughly with water. If the soil is to be

compacted to the maximum dry density at the

optimum moisture content, the exact mass of

the soil required shall be taken and the

necessary quantity of water added so that

the water content of the soil sample is equal

to the determined optimum moisture content.

(iii) Fix the extension collar and the base plate to

the mould. Insert the spacer disc over the

base. Place the filter paper on the top of the

spacer disc.

(iv) Apply Lubricating Oil to the inner side of the

mould. Compact the mix soil in the mould using

heavy compaction i.e. compact the soil in 5

layers with 55 blows to each layer by the 4.89

kg rammer.

(v) Remove the extension collar and trim the

compacted soil carefully at the level of top of

mould, by means of a straight edge. Any holes

developed on the surface of the compacted

soil by removal of the coarse material, shall bepatched with the smaller size material. Remove

the perforated base plate, Spacer disc and

filter paper and record the mass of the mould

and compacted soil specimen. Place a disc of

coarse filter paper on the perforated base plate,

invert the mould and compacted soil and clamp

the perforated base plate to the mould with

the compacted soil in contact with the filter

paper.

(vi) Place a filter paper over the specimen and place

perforated plate on the compacted soil speci￾men in the mould. Put annular weights to pro￾duce a surcharge equal to weight of base ma￾terial and pavement, to the nearest 2.5 kg.

(vii) Immerse the mould assembly and weights in a

tank of water and soak it for 96 hours. Mount

the tripod for expansion measuring device on

the edge of the mould and record initial dial

gauge reading. Note down the readings every

day against time of reading. A constant water

level shall be maintained in the tank through￾out the period.

(viii)At the end of soaking period, note down the

final reading of the dial gauge and take the

mould out of water tank.

(ix) Remove the free water collected in the mould

and allow the specimen to drain for 15 minutes.

Remove the perforated plate and the top filter

paper. Weigh the soaked soil sample and record

the weight.

टिप्पणियाँ

इस ब्लॉग से लोकप्रिय पोस्ट

हिमाचल में खुले सरकारी नौकरी के द्वार, HPSSC Hamirpur ने 554 पदों पर भर्ती को मांगे आवेदन

हिमाचल प्रदेश चयन आयोग हमीरपुर (Himachal Pradesh Staff Selection Commission Hamirpur) द्वारा जल्द 554 पदों पर भर्ती प्रक्रिया शुरू की जाएगी। आयोग द्वारा जूनियर ऑफिस असिस्टेंट (आईटी) के 200, स्टेनो टाइपिस्ट के 66 और जूनियर ऑफिस असिस्टेंट (अकाउंट) के 78 पद भरे जाएंगे। इन पदों के लिए 6 दिसंबर 2021 से लेकर 5 जनवरी 2022 तक ऑनलाइन आवेदन की प्रक्रिया शुरू की जाएगी। स्टाफ नर्स के 85,मेडिकल लेबोरेटरी टेक्नीशियन ग्रेड टू के 10, इन्वेस्टिगेटर के 3, लेबोरेटरी टेक्नीशियन का एक, फिल्ड इन्वेस्टिगेटर का एक, जूनियर स्केल स्टेनोग्राफर का एक, लेबोरेटरी असिस्टेंट के 16, रेडियोग्राफर के 4, ऑपरेशन थिएटर असिस्टेंट के 18, सेनेटरी इंस्पेक्टर के 6, जूनियर टेक्नीशियन (बुनाई मास्टर/ प्रशिक्षका) के 3, असिस्टेंट माइनिंग ऑफिसर के 2, जूनियर ड्राफ्ट्समैन इलेक्ट्रिकल के 3, फार्मासिस्ट (एलोपैथी) के 3, लाइब्रेरियन का 1, जूनियर अकाउंटेंट के दो, माइनिंग इंस्पेक्टर के 4, फार्मासिस्ट (एलोपैथी) के 7, वायरल ऑपरेटर के 3 और मेडिकल सोशल वर्कर का 1 पद शामिल है। मेडिकल लेबोरेटरी टेक्नीशियन ग्रेड दो के 2, ऑपरेशन थिएटर असिस्टेंट के 2...
 Vidhan Sabha Question Name of Department : Elementary Education UnStarred Question No. : 1792 Date of Reply : 13-12-2021 Subject : Multi Task Workers Question Raised By : Sh. Rakesh Singha (Theog): Sh. Vinay Kumar (Sri Renukaji): Minister Concerned : Education Minister Question: Will the Education Minister be pleased to state:- (a) how many cases for recruitment of multi task workers have been received by the Chief Minister under the Chief Minister quota in Education Department; (b)provide a Constituency–wise detail of each case received; and (c) what is the criteria for recruitment of multi task workers under the Chief Ministers Quota, details be given? Part (a), (b) and (c) Information is laid on the Table of House. Reply to part (a), (b) and (c) of UnStarred Question No.1792 asked by Sh. Rakesh Singha (Theog): Sh. Vinay Kumar (Sri Renukaji): regarding “Multi Task Workers”. (a) 770 applications/proposals for recruitment of Part Time Multi Task Workers have been...